33 Series Multiplast
One component ink for screen printing on sheets and pieces of materials so basic as methacrylates, polycarbonates, PVC, ABS, SAN, treated polyesters, etc.
33 SERIES leaves in all these materials a thin, hard and well adhered film, with high chemical resistance, and that with the selection of the adequate references, it can be employed for exterior use.
It must be highlighted that it leaves no residual odour.
One component ink for screen printing on sheets and pieces of materials so basic as PVC, ABS, SAN, polycarbonates, metacrylates, treated polyesters, etc.
33 SERIES leaves in all these materials a thin, hard and well adhered film, with high chemical resistance, and that with the selection of the adequate references, it can be employed for exterior use.
It must be highlighted that it leaves no residual odour.
- 33 SERIES leaves in all these materials a thin, hard and well adhered film, with high chemical resistance, and that with the selection of the adequate references, it can be employed for exterior use.
- It must be highlighted that it leaves no residual odour.
- Finish: Gloss.
- Presentation: Only viscosity needs to be adjusted, depending on the job, factory temperature and impression speed.
sheets and pieces of PVC, ABS, SAN, polycarbonates, metacrylates, treated polyesters, PET, etc..
D-200 as fast to normal and D-696 as normal to slow. Itsadequate mixture gives a good behaviour in the screen and short drying times, between 5 and 20 minutes when dried to the air, depending on the material and the job, and in seconds when passes through a tunnel.
Emulsion with ARGAZOL-E (easy decoating) or ARGAZOL-UV (high performance and definition) with meshes from 90 to 130 meshes/cm.